AI SearchApplicability analysis of waterjet cutting in the textile and leatherware industries
Call Number: AIT Thesis no. ISE-96-06 Material type:
TextSeries: Asian Institute of Technology. Thesis ; no. ISE-96-06Publication details: Bangkok : Asian Institute of Technology, 1996Description: 46 pSubject(s): Online resources: Dissertation note: Thesis (M. Eng.) - Asian Institute of Technology, 1996 Summary: Most previous published works focused on the use of wate1jets for cutting hard-to machine materials such as alloys, composites and glass. This study attempts to design and conduct the experiments to cut softer material such as fabric, natural and artificial leathers. These are the materials utilized quite popularly in the textile and leatherware industries. However, the information related to the adoption of wate1jet cutting, an emerging technology nowadays, for the mentioned materials are still scarce in the open literature. At the first stage of this research, various types of materials were tried. Then, artificial leather was selected to be investigated further due to its sufficient amount available for testing, promise to success and quite big use in the concerned sectors. The sets of suitable cutting parameters, namely pump pressure and traverse rate, for various numbers of layers were determined. All tests were conducted with the orifice diameter of 0.254 mm, the range of traverse rate from 1000 mm/min to 10000 mm/min and that of pressure from 2000 bar to 3500 bar. Based upon the obtained results, the total cutting costs for a typical part lot were calculated for both wate1jet cutting process and the current method used in the visited factory (Bangkok Rubber Company). This comparison revealed that although the wate1jet cutting is more expensive but the lead time for whole cutting process is sho1tened significantly.
| Cover image | Item type | Current library | Home library | Collection | Shelving location | Call number | Materials specified | Vol info | URL | Copy number | Status | Notes | Date due | Barcode | Item holds | Item hold queue priority | Course reserves | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
22-AIT Thesis (Replacement)
|
Asian Institute of Technology Library AIT Publications | AIT Thesis no. ISE-96-06 (Browse shelf(Opens below)) | 3 | Available | 30050120730147 | |||||||||||||
40-Archives
|
Asian Institute of Technology Library Archives | AIT Thesis no. ISE-96-06 (Browse shelf(Opens below)) | 1 | Available | 30050160098421 |
A thesis submitted in partial fulfillment of the requirements for the degree of Master of Engineering, School of Advanced Technologies
Thesis (M. Eng.) - Asian Institute of Technology, 1996
Most previous published works focused on the use of wate1jets for cutting hard-to machine materials such as alloys, composites and glass. This study attempts to design and conduct the experiments to cut softer material such as fabric, natural and artificial leathers. These are the materials utilized quite popularly in the textile and leatherware industries. However, the information related to the adoption of wate1jet cutting, an emerging technology nowadays, for the mentioned materials are still scarce in the open literature. At the first stage of this research, various types of materials were tried. Then, artificial leather was selected to be investigated further due to its sufficient amount available for testing, promise to success and quite big use in the concerned sectors. The sets of suitable cutting parameters, namely pump pressure and traverse rate, for various numbers of layers were determined. All tests were conducted with the orifice diameter of 0.254 mm, the range of traverse rate from 1000 mm/min to 10000 mm/min and that of pressure from 2000 bar to 3500 bar. Based upon the obtained results, the total cutting costs for a typical part lot were calculated for both wate1jet cutting process and the current method used in the visited factory (Bangkok Rubber Company). This comparison revealed that although the wate1jet cutting is more expensive but the lead time for whole cutting process is sho1tened significantly.
There are no comments on this title.