Gasification of wood : (Record no. 48680)

MARC details
000 -LEADER
fixed length control field 05926cas|a2200409 i 4500
005 - DATE AND TIME OF LATEST TRANSACTION
control field 20260818114820.0
008 - FIXED-LENGTH DATA ELEMENTS--GENERAL INFORMATION
fixed length control field 170699s1996 th uzm rtt 00| a1eng d
035 ## - SYSTEM CONTROL NUMBER
System control number .b11616192
099 #9 - LOCAL FREE-TEXT CALL NUMBER (OCLC)
Classification number AIT Diss no.ET-96-03
100 0# - MAIN ENTRY--PERSONAL NAME
Personal name Bui Tuyen
245 10 - TITLE STATEMENT
Title Gasification of wood :
Remainder of title a multi-stage approach
260 ## - PUBLICATION, DISTRIBUTION, ETC.
Place of publication, distribution, etc. Bangkok :
Name of publisher, distributor, etc. Asian Institute of Technology,
Date of publication, distribution, etc. 1996
300 ## - PHYSICAL DESCRIPTION
Extent 113 leaves
490 1# - SERIES STATEMENT
Series statement Dissertation ;
Volume/sequential designation no. ET-96-03
500 ## - GENERAL NOTE
General note A dissertation submitted in partial fulfillment requirements for the Degree of Doctor of Engineering, School of Environment, Resources and Development
502 ## - DISSERTATION NOTE
Dissertation note Thesis (Ph.D.) - Asian Institute of Technology, 1996
520 ## - SUMMARY, ETC.
Summary, etc. An experimental and theoretical investigation of the combustion of wood, as a single piece in air and a packed bed of pieces in a downdraft flaming pyrolysis reactor, was conducted. The results have been integrated and embodied in a multi-stage gasifier which, as the experimental tests showed, has better performance characteristics than conventional gasifiers regarding to the tar content and gas composition. The tar contamination of producer gas from conventional downdraft wood gasifiers, a recurrent headache for gasifier designers, has been identified as unavoidable because oxygen is completely consumed long before the wood pieces are completely devolatized. In a multi-stage gasifier flaming pyrolysis process is conducted in a separate reactor section, the first stage of gasifier, until the solid is completely carbonized. Another subsequent reactor section, the second · stage, where a secondary air supply is provided, is used for combustion of the pyrolysis gas and gasification of the residual char. This stage develops another temperature peak and thus is able to crack any tar that might escape oxidation. The direct phenomenological connection of the flame existence and its appearance over wood with the surface gas flux (SGF) emitted from pyrolyzing wood was investigated. The minimum flame sustaining SGF, which can also serve as the pilot ignition threshold, was determined to be about 5x10·3 kg-m·2 -s·1 {u2022} The ranges of the SGF for stable-smokeless flames were found to be quite narrow: from 15x10· 3 to 50x10·3 kg-m·2 -s·1 {u2022} At higher values of the SGF the flame was smoky indicating that combustion was incomplete. Combustion of single wood pieces in air was studied. There was found some critical size, specimens smaller than which would be ignited, burn with a flame and, produce a carbonaceous residue. Thin pieces burned more easily than thick ones but the duration of flaming combustion depended on the specimen size. Pieces thicker than the critical size did not sustain a continuous flame until volatiles were depleted, showing the need to use wood in relatively small sizes for gasification in down draft gasifier to obtain low tar gas. The opposed flow flame spread upward in a packed bed of wood pieces was studied experimentally for downdraft mode using a transparent reactor made of high temperature glass. The lower limit of supply air superficial cold velocity at which flame extinguished and the upper limit when blow off occurred were found to be about 0.02 and 0.3 mis respectively. Flaming pyrolysis of the bed was possible only at air supply within these limits. In the flame supporting air supply range, the flame spread rates were experimentally measured. Based on the knowledge gained from studies on combustion of single particle and packed bed, a multi-stage gasifier was constructed and tested. Basic conditions for successful operation of a multi-stage gasifier are favorable fuel size, air flow rate to maintain the flaming pyrolysis in the first stage and, appropriate distance between primary and secondary air supplies to ensure a sufficiently long residence time for complete wood devolatilization before the secondary air supply. Also, a proper amount of air need to be supplied to the second stage to raise temperature again; however, the solid consumption in the second stage should not cause a solid flow exceeding the opposed flow flame spread rate in the first stage. Under the optimal operation, a two-stage gasifier produced gas with tar content around 50 mg/Nm3 , about 80 times less than -ii- the best results that could be obtained with the similar size gasifier operating in conventional one-stage configuration. A one-dimensional mathematical model of a two-stage wood gasifier was developed for steady ;state operation. The numerical solution correctly predicts behavior of the gasifier qualitatively: two temperature peaks were developed, the first peak corresponded to the flame front in the first stage and the second peak was due to combustion in the second stage.
650 #0 - SUBJECT ADDED ENTRY--TOPICAL TERM
Topical term or geographic name entry element Wood
General subdivision Combustion
700 1# - ADDED ENTRY--PERSONAL NAME
Personal name Bhattacharya, Sribas C.,
Relator term Chairperson
700 1# - ADDED ENTRY--PERSONAL NAME
Personal name Loof, Rainer,
Relator term Examination Committee
700 0# - ADDED ENTRY--PERSONAL NAME
Personal name Surapong Chiraratananon,
Relator term Examination Committee
700 1# - ADDED ENTRY--PERSONAL NAME
Personal name Martin, J.,
Relator term Examination committee
710 2# - ADDED ENTRY--CORPORATE NAME
Corporate name or jurisdiction name as entry element Asian Institute of Technology,
Relator term Scholarship donor
710 2# - ADDED ENTRY--CORPORATE NAME
Corporate name or jurisdiction name as entry element The Government of Germany through the Deutsche,
Relator term Scholarship donor
810 2# - SERIES ADDED ENTRY--CORPORATE NAME
Corporate name or jurisdiction name as entry element Asian Institute of Technology.
Title of a work Disertation ;
Volume/sequential designation no. ET-96-03
856 ## - ELECTRONIC LOCATION AND ACCESS
Materials specified Full-Text
Uniform Resource Identifier <a href=" http://203.159.5.9/ait-thesis/detail.php?q=B14651"> http://203.159.5.9/ait-thesis/detail.php?q=B14651</a>
907 ## - LOCAL DATA ELEMENT G, LDG (RLIN)
a .b11616192
b mnait
c y
902 ## - LOCAL DATA ELEMENT B, LDB (RLIN)
a 240401
998 ## - LOCAL CONTROL INFORMATION (RLIN)
Operator's initials, OID (RLIN) 0
Cataloger's initials, CIN (RLIN) 970724
First date, FD (RLIN) m
-- a
-- y
-- 0
945 ## - LOCAL PROCESSING INFORMATION (OCLC)
l mnait
945 ## - LOCAL PROCESSING INFORMATION (OCLC)
l mnarc
942 ## - ADDED ENTRY ELEMENTS (KOHA)
Koha item type 22-AIT Thesis (Replacement)
942 ## - ADDED ENTRY ELEMENTS (KOHA)
Koha item type 40-Archives
909 ## - LOCAL ITEMS USED
Barcode Barcode : 30050120557409
CREATED CREATED : 2012-08-16
RECORD Id RECORD # : i12687170
LPATRON LPATRON : 1022454
LCHKIN LCHKIN : 2014-02-03
RENEWALS # RENEWALS : 0
-- # OVERDUE : 0
-- IUSE3 : 0
-- TOT CHKOUT : 1
-- TOT RENEW : 0
909 ## - LOCAL ITEMS USED
Barcode Barcode : 30050160037072
CREATED CREATED : 2016-01-25
RECORD Id RECORD # : i12873780
LPATRON LPATRON : 0
LCHKIN LCHKIN : -
RENEWALS # RENEWALS : 0
-- # OVERDUE : 0
-- IUSE3 : 0
-- TOT CHKOUT : 0
-- TOT RENEW : 0
Holdings
Withdrawn status Lost status Damaged status Not for loan Home library Current library Shelving location Date acquired Total checkouts Full call number Barcode Date last seen Copy number Price effective from Koha item type
      Available for Loans Asian Institute of Technology Library Asian Institute of Technology Library AIT Publications 18/08/2026   AIT Diss no.ET-96-03 30050120557409 18/08/2026 3 18/08/2026 22-AIT Thesis (Replacement)
      Available for Loans Asian Institute of Technology Library Asian Institute of Technology Library Archives 18/08/2026   AIT Diss no.ET-96-03 30050160037072 18/08/2026 1 18/08/2026 40-Archives
คัดลอกแล้ว!