02219nam a2200253   450000500170000000800410001703500150005810000190007324500390009226000520013130000110018349000220019450001580021650200580037452011780043265000310161065000280164170000360166970000410170570000450174671000550179181000540184685600650190020260817172309.0251197         th                  eng    a.b101306270 aVera Suwanakul10aCast in-situ piles in Bangkok clay  aBangkok :bAsian Institute of Technology,c1969  a100 p.1 aThesis ;vno. 260  aA thesis submitted in partial fulfillment of the requirements for the degree of Master of Engineering of Asian Institute of Technology, Bangkok, Thailand  aThesis (M.Eng.) - Asian Institute of Technology, 1969  aFive cast in-situ Vibro piles were cast for the testing purpose with the load cells placed at the pile tip. They were 17, 20, 23 and 24 meters long, all piles have the same diameter of 52 cm. The cyclic pile loading tests were carried out after 28 and 66 days of pile casting. The 2 and % hour loading intervals were performed to every test pile. All piles failed at the settlement between 0.45 to 0.72 inch. There is no significant change of failure load with respect to the loading interval used. The shaft friction and the end bearing capacity of the pile were determined by load cells and by the graphical method proposed by JAIN and KUMAR, The result obtained from the graphical method was between 23 to 225 and 3 to 10 percent different from the load cell method for end bearing and shaft friction respectively. The adhesion constant (a) and the end bearing capacity factor (N) were computed from the results of the two methods. They were 0.49 to 0.89 and 3.94 to 14.22 based on the shearing strength obtained by vane shear and or standard penetration tests. For the results based on unconfined compression tests they were 1.03 to 1.37 and 4.69 to 15.50 respectively. 0aPiling (Civil Engineering) 0aClayxThailandxBangkok0 a Chai Muktabhant, eChairperson1 aBrand, E.W., eExamination Committee1 aNelson, John D., eExamination Committee2 aAsian Institute of Technology, eScholarship Donor2 aAsian Institute of Technology.tThesis ;vno. 260  3Full-Textuhttp://203.159.5.9/ait-thesis/detail.php?q=B24674