TY  - BOOK
AU  - Kung,Teliang
AU  - Arbhabhirama Anat
AU  - Ackermann,Norbert L.
AU  - Silvester,Richard
ED  - Asian Institute of Technology, 
TI  - Characteristics of flow past circular disk placed near the end of a circular pipe
T2  - Thesis
PY  - 1969///
CY  - Bangkok
PB  - Asian Institute of Technology
KW  - Hydraulics
N1  - A thesis submitted in partial fulfillment of the requirements for the degree of Master of Engineering of the Asian Institute of Technology, Bangkok, Thailand; Thesis (M.Eng.) - Asian Institute of Technology, 1969
N2  - Characteristics of a flow past a circular plate placed near the end of a pipe was investigated. The theoretical solutions were obtained from the solutions of the two-dimensional counterpart under the assumption that the final line integration in the two-dimensional case was replaced by the corresponding surface integration. The equations expressing the jet deflection angle, the ratio between the velocity of the uniform flow in the pipe to the velocity of jet, and the coefficient of hydrodynamic drag were obtained as functions of the boundary geometry. The experiments were conducted to verify the theoretical equations. The experimental results for the jet deflection angle and the velocity ratio were found to be less than the theoretical values. However, the trends of the theoretical and experimental curves were very similar. The discrepancies between the theoretical and experimental results of the deflection angle and the velocity ratio were found to be approximately constant for all the values of the dimensionless parameters representing the boundary geometry. Empirical equations were also developed to relate the theoretical and experimental values of the jet deflection angle and the velocity ratio
UR  - http://203.159.5.9/ait-thesis/detail.php?q=B24665
ER  -