02008nas|a2200229 i 450000500170000000800410001703500150005810000220007324500750009526000520017030000100022249000280023250001400026050200580040052010480045865000280150670000320153470000450156670000420161181000600165385600650171320260818134448.0150799s1998    th  uzm rtt  00|  a1eng d  a.b1175509x0 aNarudom Therdkiet10aImpacts of rapid prototyping on product design and development process  aBangkok :bAsian Institute of Technology,c1998  a51 p.1 aThesis ;vno. ISE-98-37  aA thesis submitted in partial fulfillment of the requirements for the degree of Master of  Engineering, School of Advanced Technologies  aThesis (M.Eng.) - Asian Institute of Technology, 1998  aThe purpose of this thesis study was to implement the rapid prototyping technology to  the product design and development process and analyze the impact of them.  This thesis study was concerning the air-conditioner remote controller design and  development supported by Intronic Co., Ltd. There are two proposed remote controller design,  the wall mounted remote controller and desktop remote controller, and one packaging design.  The design and development process was perform systematically from the conceptual design,  embodiment design, detailed design, rapid prototyping fabrication, assembly test, and design  analysis.  The 3D CAD system is used to produce mostly output from the virtual prototype, 3D  solid model, STL file, and 2D dimension drawing. The prototypes were fabricated by Fused  Deposition Modeling (FDM) Method at Kasetsart University.  The analysis was about to compare between the product design and development  process with and without the implementation of rapid prototyping technology, in term of time  and cost.  0aPrototypes, Engineering1 aNaber, Helmut,eChairperson1 aBohez, Erik L.J.,eExamination Committee1 aIgel, Barbara,eExamination Committee2 aAsian Institute of Technology.tThesis ;vno. ISE-98-37  3Full-Textuhttp://203.159.5.9/ait-thesis/detail.php?q=B13346