Nguyen Ba Quang creator Salokhe, Vilas M. Chairperson Singh, Gajendra Examination Committee Clough, David Gee Examination committee Gupta, C. P. Examination committee The Government of The Netherlands Scholarship donor text th Bangkok Asian Institute of Technology 1994 monographic eng

print

91 leaves : ill. Experiments were conducted in a laboratory soil bin having Bangkok clay soil with average moisture content of 18% (db) and cone index of about 1100 kPa. The disk having 510 cm diameter and 560 mm radius of concavity was used. Disk angle from 20 to 35°, ground speed from 1 to 3 km/h and rotational speed from 60 to 140 rpm were varied. The working depth was kept constant at 12 cm. It was observed that disk angle, rotational speed and ground speed had significant effect on soil reactive forces and power requirement. At small disk angle, low ground speed, and high rotational speed, the soil longitudinal reactive force was a pushing force and became a resistive one at larger disk angle and ground speed. The soil transverse reactive force increased with the increase of rotational and ground speed but decreased with the increase of disk angle, while the vertical reactive force increased only with the increase of ground speed but decreased with the increase of rotational speed and disk angle. It was found that the powered disk required smallest power at disk angle of 30° and rotational speed between 80 and 100 rpm. As ground speed increased, total power requirement increased. Increase in ground speed from 1 to 3 km/h increased the total power requirement by 31. 8 3 . At driving the disk forward, the draft reduced considerably as compared with that of the free rolling disk. By driving the disk in reverse direction the draft reduced slightly. At disk angle of 30°, rotational speed of 100 rpm, and ground speed of 3 km/h, the total power requirement of the forward driven disk was 65 % higher than that of the free rolling disk. The predicted engine power of the forward driven disk, however, was only 21 3 higher than that of the free rolling one owing to the more efficient power transmission through PTO than via drawbar. A thesis submitted in partial fulfilment of the i·equirement for the degree of Master of Engineering. Thesis (M.Eng.) - Asian Institute of Technology, 1994 Disks, Rotating Asian Institute of Technology. http://203.159.5.9/ait-thesis/detail.php?q=B15948 http://203.159.5.9/ait-thesis/detail.php?q=B15948 080598 20260818171601.0