| 000 | 04043nam a2200409 a 4500 | ||
|---|---|---|---|
| 005 | 20260818085348.0 | ||
| 008 | |||
| 035 | _a.b11494827 | ||
| 099 | 9 | _aAIT Thesis no. EV-95-10 | |
| 100 | 1 | _aNiriella, D. P. W. H. | |
| 245 | 1 | 0 | _aCoupling of dissolved air flotation and crossflow microfiltration for the separation of fiber |
| 260 |
_aBangkok : _bAsian Institute of Technology, _c1995 |
||
| 300 |
_a135 leaves : _bill. |
||
| 490 | 1 |
_aThesis ; _vno. EV-95-10 |
|
| 502 | _aThesis (M. Eng.) - Asian Institute of Technology, 1995 | ||
| 500 | _aA thesis submitted in partial fulfillment of the requirements for the Degree of Master of Engineering. | ||
| 520 | _aThe goal of this research was to investigate the possibility of coupling Crossflow Microfiltration (CFMF) with Dissolved Air Flotation (DAF) for fiber separation. In the first stage of experiments, a Jar test was conducted to obtain optimum Alum and polyelectrolyte dosage required to produce floes. In the second stage, DAF batch experiments were conducted to investigate the effects of saturation pressure, recycle ratio and A/S ratio on the suspended solids removal. In the third stage CFMF runs were conducted to optimize the parameters which effect the flux in CFMF operations. During this stage the following parameters were examined. Crossflow velocity (2.0-6.0 m/s), feed concentration (100-2000 mg/L), transmembrane pressure (50-300 kPa), membrane pore size (0.2-5.0 micron). Once the optimum parameters were found they were tested for both flocculated and unflocculated feed. At the fourth stage, coupling DAF with CFMF was done inorder to observe the effects the introduction of air bubbles would have on permeate flux. In these runs saturation pressure of 400-800 kPa and recycle ratio of 8-30 % was adopted. From the stage one runs, it was found that an alum and polyelectrolyte dose of 140 and 0.5 mg/L was required at pH = 6.0 to fully destabilize fiber and to form floes . From stage two, it was found that with increasing recycle ratio there was an increased suspended solids removal. Here 97 % suspended solids removal rate was achieved at an A/S ratio of 0.075. Results from stage three show that permeate flux increased with increased crossflow velocity upto 4.0 mis and thereafter further increases in velocity decreased flux. Increases in transmembrane pressure increased flux , whereas there was an inverse relationship between feed concentration and flux. The addition of alum and polyelectrolyte decreases permeate flux by near! y 100 % . In stage four, with the introduction of air bubbles, flux increased beyond the flux obtained by stage three runs only beyond a bubble number concentration of 2.3*105 No./mL. for flocculated feed. However, for unflocculated feed this was not observed. | ||
| 650 | 1 | 0 | _aFilters and filtration |
| 700 | 1 |
_aVisvanathan, C., _eChairperson |
|
| 700 | 1 |
_aAnnachhatre, Ajit P., _eExamination Committee |
|
| 700 | 1 |
_aBoonthanon, S., _eExamination committee |
|
| 710 | 2 |
_aSwedish International Development Authority, _eScholarship donor |
|
| 810 | 2 |
_aAsian Institute of Technology. _tThesis ; _vno. EV-95-10 |
|
| 856 |
_3Full-Text _uhttp://203.159.5.9/ait-thesis/detail.php?q=B15116 |
||
| 907 |
_a.b11494827 _bmnait _cv |
||
| 902 | _a240404 | ||
| 998 |
_b0 _c960625 _dm _ea _fv _g0 |
||
| 945 | _lmnait | ||
| 945 | _lmnait | ||
| 945 | _lmnarc | ||
| 942 | _c20 | ||
| 942 | _c40 | ||
| 909 |
_aBarcode : 30050004036215 _bCREATED : 1994-12-22 _cRECORD # : i11758697 _dLPATRON : 1015812 _eLCHKIN : 2003-11-02 _f# RENEWALS : 0 _g# OVERDUE : 0 _hIUSE3 : 0 _iTOT CHKOUT : 1 _jTOT RENEW : 1 |
||
| 909 |
_aBarcode : 30050004036199 _bCREATED : 1994-12-22 _cRECORD # : i11758715 _dLPATRON : 1012449 _eLCHKIN : 1999-01-09 _f# RENEWALS : 0 _g# OVERDUE : 0 _hIUSE3 : 0 _iTOT CHKOUT : 2 _jTOT RENEW : 2 |
||
| 909 |
_aBarcode : 30050160079355 _bCREATED : 2016-05-23 _cRECORD # : i1298520x _dLPATRON : 0 _eLCHKIN : - _f# RENEWALS : 0 _g# OVERDUE : 0 _hIUSE3 : 0 _iTOT CHKOUT : 0 _jTOT RENEW : 0 |
||
| 999 |
_c24110 _d24110 |
||